#gentoo - Wed 21 Feb 2007 between 20:38 and 20:46

NY Lost Funds



reisiodon't be sorry, either :/
g-hennahi!
bennice, WANT_AUTOMAKE works :)
reisio'lo henna
benthnx a lot man, it was driving me crrzy
g-hennahow can i easily allow the whole kde 3.5.6 stuff to be emerged without setting for each package?
todd3834is there a command to unmodprobe somethign?
g-hennatodd3834: rmmod
ErZormmod, modprobe -r
jd86tar+netcat = good.
todd3834thanks! :)
hydrogeng-henna: you can't
pekstertodd3834: It's usually good to start with modprobe -r first, and then use rmmod if the 1st didn't work, since rmmod is a bit less "nice" when it removes the module
g-hennahydrogen: ok, thanks
Logix101using the ati drives on linux even the opengl screen savers lag
g-hennahydrogen: not even with kde-base/* ~x86 or so? :-(
Logix101i would assume tweaking will be needed
zling-henna: what did that question mean?
peksterLogix101: Is Direct Rendering enabled?
g-hennaand when will packages get unmasked?
hydrogeng-henna: no, you could wrong some ugly bash foo to automate it but it would still be one entry->one package
Logix101pekster: is that a setting in the xorg.conf?
Mercestesazomg, 10 of 39. I'm so not watching this.
Goodnite peeps.
g-hennahydrogen: ok...
MercestesThanks Zlin and loki for your help. Your both awesome
hydrogeng-henna: minimum of a month after they were added to the tree, but with the main kde dev retiring recently not sure how much longer it may or may not be
zling-henna: ooh.. you can if you use paludis.
peksterLogix101: Yea, you need Load "dri" under your "Module" section, and you probably also want the Mod 0666 under the "DRI" section (sometimes this is already there for you in xorg.conf commented out at the bottom)
g-hennahow long will it take until kde-3.5.6 gets unmasked?
peksterLogix101: You can check if DRI is enabled right now if you're in X by issuing this command at a terminal within X: glxinfo | grep render
reisiog-henna: as long as it takes for you to learn how to unmask it
Logix101libGL error: failed to open DRM: Operation not permitted
libGL error: reverting to (slow) indirect rendering
marienzpermissions on /dev/dri/card0
Logix101why doesnt ctrl v and p work in kde damnit
netherworldHello! A simple question... How can I list recursively all directories but just the directories and not the files?
Logix101need that :)
marienzprobably too restrictive, check you're in the video group, check if /etc/X11/xorg.conf sets that correctly (DRI section there)
netherworld: find -type d

Page: 2 9 16 23 30 37 44 51 58 65 72 79 86 93 100 107 114 121 128 135 142 149 156 163 170 177 184 191 

IrcArchive

NY Lost Funds